ASROCK K10N7SLI Bedienungsanleitung PDF herunterladen (Seite 26)

2626

FLOPPY1

Pin1

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

2.7 Onboard Headers and Connectors2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.12, No. 25)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.12, No. 9)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA II Connectors These six Serial ATAII

(SATAII_1 (PORT0): (SATAII) connectors support

see p.12, No. 17) SATA data cables for internal

(SATAII_2 (PORT1): storage devices. The current

see p.12, No. 14) SATAII interface allows up to

(SATAII_3 (PORT2): 3.0 Gb/s data transfer rate.

see p.12, No. 16)

(SATAII_4 (PORT3):

see p.12, No. 15)

(SATAII_5 (PORT4):

see p.12, No. 13)

(SATAII_6 (PORT5):

see p.12, No. 12)

SATAII_6 (PORT5) connector can be used for internal storage device

or be connected to eSATAII connector to support eSATAII device.

Please read “eSATAII Interface Introduction” on page 33 for details

about eSATAII and eSATAII installation procedures.

SATAII_6 (PORT5)

SATAII_5 (PORT4)

SATAII_4 (PORT3)

SATAII_3 (PORT2)

SATAII_2 (PORT1)

SATAII_1 (PORT0)

80-conductor ATA 66/100/133 cable

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

ASROCK K10N7SLI Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motherboards ASROCK K10N7SLI