ASROCK 960GC-GS FX Bedienungsanleitung PDF herunterladen (Seite 24)

System Panel Header This header accommodates

(9-pin PANEL1)

several system front panel

(see p.12 No. 19)

functions.

Connect the power switch, reset switch and system status indicator

on the chassis to this header according to the pin assignments below.

Note the positive and negative pins before connecting the cables.

PWRBTN (Power Switch):

Connect to the power switch on the chassis front panel. You may con-

gure the way to turn off your system using the power switch.

RESET (Reset Switch):

Connect to the reset switch on the chassis front panel. Press the reset

switch to restart the computer if the computer freezes and fails to per-

form a normal restart.

PLED (System Power LED):

Connect to the power status indicator on the chassis front panel. The

LED is on when the system is operating. The LED keeps blinking

when the sys-tem is in S1 sleep state. The LED is off when the system

is in S3/S4 sleep state or powered off (S5).

HDLED (Hard Drive Activity LED):

Connect to the hard drive activity LED on the chassis front panel. The

LED is on when the hard drive is reading or writing data.

The front panel design may differ by chassis. A front panel module

mainly consists of power switch, reset switch, power LED, hard drive

activity LED, speaker and etc. When connecting your chassis front

panel module to this header, make sure the wire assignments and the

pin assign-ments are matched correctly.

For Windows

8 / 8 64-bit / 7 / 7 64-bit / Vista

/ Vista

64-bit OS:

Go to the "FrontMic" Tab in the Realtek Control panel. Adjust

“Recording Volume”.

SPDIF Out Connector Please connect the

(2-pin SPDIF_OUT1)

SPDIF_OUT connector of a

(see p.12 No. 24)

HDMI VGA card to this header

with a cable.

SPDIFOUT

GND

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Keine Kommentare

ASROCK 960GC-GS FX Bedienungsanleitung Seite 24